If you use the machine regularly the following routine should be carried out daily:

Firstly, switch the machine off at the front. Place a bucket under the rear hopper and open the hopper hatch. The abrasive that falls into the bucket can be put straight back into the machine via the front window. Then place the bucket back under the rear hopper and pull the black knob located on the left hand side of the machine ( when viewed from the rear) in and out vigorously several times. This will dislodge any waste abrasive from the dust bag which will then fall into the bucket. This needs to be disposed of as it is waste. Close the rear hopper hatch. Remember, you will need to top up the abrasive in the machine with new abrasive, to replace what has been disposed of.

You will need to replace the abrasive fully after approx. 1000 engravings as by then the abrasive will become blunt. If the abrasive is a grey colour it is a good indication that it needs changing.

The dust bag will require changing after 100 hours or six months.

There are two wearable parts on the engraving gun itself, one being the nozzle (T75) and the other being the Air Jet (T85). These will need replacing every six months depending on use. A good indication of worn gun parts is if the abrasive comes out of the end of the gun in a scattered manner rather than in a tight straight stream.

The cabinet gloves will wear eventually, and can be replaced.

All of the cabinet consumables can be obtained from Crystal Galleries via the Sales Office.